This list contains the required parts for the DIY-Thermocam V3 thermal imager:
- 1 x FLIR Lepton 3.5 (160x120) OR FLIR Lepton3.1R (160x120) OR FLIR Lepton2.5 (80x60)
- 1 x FLIR Lepton Breakout Board V2.0
- 1 x PCB
- 1 x 2D Laser Cutted Enclosure OR 3D Printed Enclosure (3mm Acryl GS Grey for Laser Cutted Enclosure)
- 1 x Pololu 5V Step-Up Voltage Regulator U3V16F5
- 1 x 3.2 Inch TFT LCD Touch Display (Pin Header Connection-4-wire-SPI, Power Supply: 5V, Touch Panel: 3.2" Resistive, Font Chip: None)
- 1 x Samsung Battery EB-BG355BBE (or Li-Ion battery with similar capacity and dimensions)
- 1 x Power Switch
- 1 x Push Button
- 1 x Coin Cell Holder
- 1 x Display Connector
- 1 x Lepton Connector
- 4 x 4.7k Resistor 1% Axial
- 2 x 10k Resistor 1% Axial
- 1 x microUSB Cable (>= 0.3m)
- 1 x CR1220 Coin Cell Battery
- 1 x Teensy 4.1 Microcontroller
- 1 x 2.54mm Male Header Strip (you need 80 pin in total)
- 1 x 2.54mm Female Header Strip (you need 120 pin in total)
- 1 x Lepton Protector (link contains 3 pieces, only one is needed per unit)
- 1 x Double-Sided Tape for Battery (German link, only for comparison, makes 12 pieces out of each)
- 1 x Short Pieces of Shrinking Tube 3:1, 4,5mm
- 1 x Short Pieces of Red Cable Stranded Wire 26AWG
- 1 x Short Pieces of Black Cable Stranded Wire 26AWG
- 1 x Tripod Socket (link contains 13 pieces, only one is needed per unit)
- 1 x TP4056 Charging Module (the PCB has been designed for TP4057 but it is out of stock - check out this page for further discussions)
- 1 x 16GB Class10 microSD card (any size works, but should be Class10 for best performance)
- 4 x Screw M2x18 (Can be found at any hardware store)
- 4 x Spacer M2x12 (Can be found at any hardware store)
- 3 x Screw M2x8 (Can be found at any hardware store)
- 4 x Standoff M2.5x11 (Can be found at any hardware store)
- 4 x Standoff M2.5x20 (Can be found at any hardware store)
- 4 x Standoff M2.5x5 (Can be found at any hardware store)
- 4 x Nut M2 Plastic (Can be found at any hardware store)
- 3 x Nut M2 Zinc (Can be found at any hardware store)
- 3 x Washer M2 Steel (Can be found at any hardware store)
- 8 x Screw M2.5x6 (Can be found at any hardware store)